Wacom CTF-220 Manual de usuario descargar pdf (Pagina 50)

XT[2] Series DISK RECORDER

Version 10.04 - Hardware

Technical Reference Manual

Issue

10.04.A

EVS Broadcast Equipment

–

January 2011

LOCK

IAGRAM

UMPERS ON THE

COHX

ASE

ODULE

ST1, ST2: These 2 jumpers must be installed on the last COHX board of

the server (i.e. on COHX #1, 2 or 3 if there are respectively 1,

2 or 3 COHX board installed in the server)

ST3 (SPARE): « parking » for jumpers for ST1 and ST2 when these are not

used

ST4 (only on

COHX with

genlock) :

It must be set to HiZ (or not installed).

Note that the Genlock Loop connector on the back panel of the

XT[2] server must always

be terminated with a 75 Ohm load if it

is not used.

ST5 : It defines the position of the board inside the server.

It must be set to « 1 » for a COHX with genlock, and to « 2 » or

« 3 » for a COHX board without genlock, depending on its

position in the server.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 69 70

Sin comentarios

Wacom CTF-220 Manual de usuario Pagina 50